HOME | PRODUCTS | WHO USES | PRICES | ABOUT US | CONTACT |
Antenna Switch


  • Antenna Switch with 12inputs by two output remotely controlled.
  • Aluminum cabinet painted in the dark gray color, having UHF type (SO-239) for the R.F connections and DB-25 for remote control.
  • All antenna inputs are switched to ground when not in use.
  • When the power are switched off, all antenna inputs are routed to ground for protection purposes.


Specification:

Size:

Width 45 cm - Height 5 cm - Deep 15,5 cm

Power Supply:

D.C. 14 Volts + or - 20% drain about 100mA

Max. SSB power allowed:

4000 Watts P.E.P. with S.W.R. equal or less than 1.7:1

Frequency of operation:
D.C. to 60MHz
Time delay to switch:
Equal or less than 50ms (exchange forbidden during TX)
Insertion loss:
Equal or less than 0,1dB
Port Isolation worst conditions measurements:

Equal or less than -84dB to 30MHz

Port Isolation worst conditions measurements:

RX 1
RX 2

Connections suggestions:

12 antennas 2 radios solution diagram
The switch AS-1202F receives the signals from twelve antennas selecting one of them for each radio (two of then), leaving the others not in use, shorted to ground. In the case of power supply disconnection, the radios became free and all antennas are grounded.

 

12 antennas 2 radios and 4 rotators solution diagram

 

More Hamplus:
Copyright Hamplus .